Return Conveyors Choose the model for your application: Turnbak for Edgebanders Photo-eye detects the trailing edge of parts coming from a machine. This causes the receiver rollers to lower. Urethane belts move parts from the receiver section to the return. After the part leaves the receiver section, the rollers raise and the cycle is repeated. Comebak for Moulders Powered feed roller guides parts onto the receiver. Acetal (plastic) chains transfer parts from the receiver section to the return section. The process is continuous, so parts may be butt-fed! Available in two versions: S.P. Stripper Plate for Return Only T.R. Thru Roller for Pass-Thru Ability CutBak for Saws Photo eye detects the trailing edge of parts coming from a machine. This causes the receiver rollers to lower. Urethane belts transfer the parts to the return section. After the part leaves the receiver section, the rollers raise and the cycle is repeated. Paybak for Shapers Economical design ideal for the smaller operation or standardized parts. In-feed hold down to insure complete part acceptance. Durable, heavy duty steel construction. Adjustable in-feed to match most any machine. Adjustable jack legs to match most any machine height. Close belt spacing to aid in the transfer of smaller parts. Available in several sizes to fit your application. SandBak for Sanders Photo Eye detects trailing edge of part. Receiver Infeed Section lowers onto crossbelts which move part laterally to return side. Part is returned to operator while Receiver Infeed Section raises to repeat cycle. If you don’t see a machine to fit your application, don’t hesitate to contact us. .